T-Strip Drum Spill Pallet Connector for Ultra-Spill Deck Plus, 26"

Each UltraTech 1131 T-Strip is 26 inches length.

Features:

• Prevents spills from going between decks
• 26 inches length (Use 2 for Longer spill pallet sides)
• T-strip
• Ultra-Spill Pallet
• How does it work- Gentoo is a dense polymer system that forms a barrier against corrosion initiators. This is due to its low surface energy, high density, and low porosity. The system is conformal, pin-hole free, and very thin (4-6 microns) compared with traditional polymer coatings but far more dense and durable. The higher density of the system provides an excellent barrier to water and corrosive ions.
• Adhesion & Durability - Gentoo has robust adhesion to painted, plated, and bare metallic substrates, as well as glass and surface primed plastics. The coating has demonstrated excellent resistance to salt spray, UV exposure, and chemical exposure -significant improvements over traditional hydrophobic coatings.
• Corrosion Resistance When used on top of other qualified systems, Gentoo further reduces corrosion and extends the lifetime of the barrier system and therefore the coated substrate. This is due to its excellent water and salt shedding properties and impact resistance. These properties also significantly reduce the effects of galvanic corrosion of dissimilar metals.
• Easy Cleaning The low sliding angle combined with the high dirt and solvent resistance of the coating allows for easy cleaning of many surfaces with less water. See the video below to see testing that was done to test Gentoo for anti-graffiti applications.
• Application Gentoo is a two-part coating that is mixed together and then applied as a single coat. It can be flow-coated, dip-coated, HVLP sprayed or painted on with a brush or roller. It provides a lightweight, thin (4-6 microns) coating with minimal surface preparation.
• Chemical Resistance Offers superior resistance to most oils, solvents, and acids.
• Made in the USA.

Documents

• Gentoo- Flyer
• Gentoo- Technical Data Sheet
• Gentoo- Part A- SDS

Q& A

What does a t-strip do?  

The T-Strips lay across the point where two Spill Decks come together.  By “bridging the gap” this piece diverts spills to either of the Decks and keeps any spillage from getting between the units.

I need to add another Spill Deck to the one I already have.  What do I need?  

Other than the additional Spill Deck, you’ll need one Bulkhead Fitting (part# UT-1073) and one T-Strip (part# UT-1131) for every 27-1/4" of Spill Deck length that is connected.  For example, if you’re connecting a 4-Drum Spill Deck to another 4-Drum Spill Deck you would need two Bulkhead Fittings and two T-Strips.  If, on the other hand, you were connecting a 2-Drum Spill Deck on the short end, you would only need one each of the Bulkhead Fitting and T-Strip.