Bulk discount rates
Automatically save when you buy in bulk.
|Buy 6 - 11||and get 10% off|
|Buy 12 or above||and get 15% off|
Bel-Art 500250008 8 in. O.D. glove box port covers. Use these glove box port covers to seal off any glove ports to which gloves are not attached. Simply press the covers into the port opening until the flange on the cover meets the glove port.
- One-piece construction with a neoprene gasket for a snug fit
- Fit glove ports with a 20.3cm (8") O.D.
|BA-500250008||Covers for 8" Ports|
How to apply cover over an 8" Diameter Port Opening:
- Place cover over the outer edge of port.
- Work cover over the side of the port, gently stretching sides as necessary, until the entire cover sits flush against the port.
Secure Cover With Band Clamp:
- The band clamp is shipped in the fully opened position.
- Push screw up until it is perpendicular to the band and disengaged from the slots of the clamp.
- Insert approximately 1 inch of the free end of the slotted band under the screw.
- Push screw down until it is parallel to the band and engaged with the slots of the band clamp.
- Place the Band Clamp over the Cover midwayalong the cylindrical part of the cover.
- Turn the screw clockwise with a 5/16" nut driver or a flat screw driver to create a snug fit. Tighten firmly until the band cannot move.
CAUTION: Do not over-tighten.
NOTE:There should be no space between the band clamp and the cover.